Advertisement
Remote control unit
RC-V6000L
Other remote
Oo
ovde
/
Lights.
Example:
To program the REPEAT
function signal of the
other remote control unit in this remote control
unit (RC-V600O0L):
Press and hold.
Transmission/
Blinks.
REPEAT
is programmed
un-
der this key.
18
ka-v6000 (En)
@ How to program the remote control func-
tions
of
other
components
under
the
"learning"
keys
of the
RC-V60O0OL
re-
mote control unit.
1. Set the LEARN/USE
switch to LEARN.
Set the AUDIO/VIDEO/AUX
switch
(A/B/C)
to the
required position.
2. Place the remote
control
unit of another component
with this remote control unit (RC-V6000L) so that their
heads
(signal transmitters)
face
each
other (at a dis-
tance of 2 to 5 cm, or 0.8 to 2 inches).
3. Press the learning key of the RC-V6000L under which
you want to program the function signal.
The LEARN
indicator will light up.
4. Within 30 seconds after pressing the key above, press
the key of the other remote control unit which contains
the function to be programmed (stored).
The LEARN
indicator changes from steady lighting to
blinking,
indicating
that the function
signal is being
programmed.
5. When the LEARN
indicator blinks twice then goes off,
it indicates
that
the
signal
has
been
programmed
(stored). Release your finger from the key of the other
remote control unit.
Note:
Be
sure
to hold
the
key of the
other
remote
control
unit
depressed until the LEARN
indicator goes out.
®To
program
(store) another
function
signal
under
another key, repeat steps 3 to 5 above.
Advertisement
