Kohler Kumin K-104K37-SANA-CP Installation Instructions Manual page 9

4. Connect the Supplies
Flex Hose
Inlet Connections
Connect the flex hose to the supply stop.
Place a bucket under the supply stop and turn ON the water supply.
Slowly open the supply stop to flush debris.
Turn OFF the water.
Connect the provided flex hose from the supply stop to the control box.
Outlet Connections
Verify that the tube from the spout is the appropriate length to reach the control
box. Cut the tube if necessary. Remove any burrs and sharp edges.
Insert the tube into the fitting (control box outlet end) until the tube stops.
Verify that the tube is secure.
Kohler Co.
Flex Hose
Supply Stop
Inlet
Outlet
9
Tube
From Spout
1561532-2-A