Maintenance And Storage; Troubleshooting - Jimmy BX6 Pro User Manual

Dust sensor cleaning
Dust sensor is installed inside of air inlet. Use
mini brush to clean inner wall of air inlet to avoid
too much dust accumulating on dust sensor and
cause abnormal display of dust level. (Figure 6)

Maintenance and Storage

Please clean dust cup and HEPA filter after each use for further use. It is recommended
to replace a filter after 30-50 hours of working time(depending on specific situation) for better
use.
Any paper, lead glass, plastic will greatly affect the effect of UV light. Dust or stain on UV light
cover will affect the effect of UV light. Please wipe and clean the UV light cover regularly
for better use.
Do not touch the UV light cover as dirt will affect UV light effect.
Put the machine in cool and dry place if the machine is to be idled. Do Not leave it in
direct sunlight or humid environment.
Trouble Shooting
Please check the following trouble points before contacting after service.
Problems
Product does
not turn on
Weak suction
UV light does
not work
21
Possible Reasons
On/off switch is not pressed down
No power on socket
Power cord is not firmly inserted
Air inlet blocked
HEPA blocked
Cyclone blocked
Machine tilt and micro switch
left cleaning surface
UV light defect
5
Brushroll
Brushroll cover
Solution
Press down on/off switch
Check the socket
Check whether the power plug
is firmly inserted
Clean air inlet
Clean dust cup and HEPA
Clean cyclone
Machine tilting degree cannot
ex-ceed 30 degree
Contact after service to replace
UV light
6
Air inlet