Settings - Cambridge Audio CXN100 Manual

32

Settings

Last updated: February 1, 2024 01:38. Revision #11524
Device Name
This is how your player will appear in your StreamMagic app and on your home network when using services like Spotify, Chromecast built-in and
TIDAL Connect.
Giving your player a unique name makes it easier to distinguish when using streaming and smart home services.
AirPlay Name
This is how your player will appear when using AirPlay or the Apple Home app.
Standby Mode
This selects what type of standby mode your player will use.
Network Standby means your player will still be controllable by the StreamMagic app and other network services while in standby.
If ECO mode is chosen, your player will use even less power in standby but will need to be switched on either by the front panel or the remote
control. It will not be controllable via the app or other network services while in standby.
Automatic Power Down
This sets how long your player will wait while inactive before switching to standby.
Display Brightness
This sets the brightness of your player's display. If set to 'Off' the display will show for a few seconds after any change and then switch off.
Roon Ready DSD
This will allow you to choose how Roon provides DSD content.
Use DoP for digital output – If your device does support native DSD in DoP format.
Use PCM for digital output – If your device doesn't support native DSD.
Control Bus
If your device is connected to a Cambridge Audio amplifier using a control bus connector, volume commands can be sent directly to the amplifier.
For more information, please refer to the Getting Connected section of this manual under 'Control Bus' here.
Pre-Amp
With Pre-Amp mode enabled, the volume of the device's analogue outputs can be controlled using the app or rotary dial.
For more information see our FAQ.
Note: Pre-Amp mode and volume control can only be enabled when connected via the analogue outputs.
Volume Limit
This sets the maximum volume that other streaming services like AirPlay, Spotify, TIDAL Connect and Chromecast built-in can set. The front panel,
remote control and StreamMagic app volume controls can override this setting.
Early Update
Setting this to 'On' will let you try out the latest firmware ahead of general release.
For more information and to find out what's new visit our FAQ.