Settings - Cambridge Audio CXN V2 Manual

Settings

NETWORK
Set-up Wi-Fi: Initiates Wi-Fi setup.
Enter network name: For manual entry of the network name.
Current config: Displays current network settings.
Edit config:
• Auto (DHCP).
YES (recommended).
NO – settings are manually entered.
If 'NO' is selected, you will need to enter (using the navigator and select
buttons) the CXN v2' s IP address, Network mask, Gateway address and DNS
server(s).
Wi-Fi strength
Signal warning: On-screen warning of low Wi-Fi signal strength.
Wi-Fi region: Select the region that closest matches your location.
Wired/Wi-Fi:
• Auto (default).
• Wired only.
• Wi-Fi only.
FIRMWARE
• Check for updates and display version number.
DISPLAY BRIGHTNESS
DEVICE NAME
Rename the CXN v2.
AUDIO
• Digital pre-amp mode.
On – enables volume control.
Off – fixed output.
Balance – only available if Digital Pre-amp Mode = On.
• USB audio class.
1.0 – for greatest compatibility with computers.
2.0 – allows high sample rate audio (up to 24-bit/192kHz sample rate).
You may need to download and install the Cambridge Audio USB
Audio class 2.0 driver.
For further information on USB Audio: www.cambridgeaudio.com/USB-
audio.
REMOTE CONTROL
Used when there is a clash with other products.
• CXN v2 Series handset (24) (default).
• CXN v2 Series handset (28) – alternate set IR remote control commands.
• No IR control – disables the CXN v2 from responding to IR remote control
commands.
To use the alternate set IR remote control commands, both the CXN v2 and
the CXN v2 IR remote control handset must be reconfigured:
• CXN v2 – select CXN v2 Series handset (28) in the above menu.
• Remote control – perform the following steps:
Remove the batteries from the CXN v2 IR remote control.
Press and hold the 'Power' button while reinserting the batteries.
Note: To restore the default CXN v2 IR remote control command set,
remove and reinstall the batteries without pressing any buttons.
LANGUAGE
STANDBY MODE
• Network Standby – network connections remain active and the
StreamMagic app can turn on the CXN v2.
• ECO mode – all audio, network and control circuits are shut down.
AUTOMATIC POWER-DOWN
Sets the time before entering Standby Mode after inactivity.
EDIT INPUT NAMES
Allows you to customise the names of the digital inputs; USB Audio and
D1 – D2.
FACTORY RESET
Restores the CXN v2 to the default factory shipping state.
Note: Factory reset will delete all Wi-Fi networks and keys from memory..
CXN V2
7