Troubleshooting; Manufacturer's Warranty; Further Information - Hilti NURON SC 6WP-22 Manual

▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9

Troubleshooting

If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
The on/off button cannot be
pressed, i.e. the button is
locked.
Running speed suddenly
drops considerably.
No suction power or reduced
suction power
The product doesn't restart
by itself after the saw blade
has stalled.
The battery does not engage
with an audible click.
Product vibrates more than
usual.
LEDs of the battery show
nothing
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
qr.hilti.com/manual?id=2276670
16 English
Possible cause
Not a fault (safety function).
Battery is discharged.
Saw advance pressure is too high.
The chip / dust channel is blocked.
The overload cut-out has been
activated.
The retaining lugs on the battery
are dirty.
The saw blade is fitted incorrectly.
Battery defective
technology, environment and recycling,
Action to be taken
▶ Press the switch-on interlock.
▶ Charge the battery.
▶ Reduce advance pressure and
switch the power tool back on.
▶ Clean the chip ejector channel.
→ page 15
▶ Press the switch-on interlock
and the on/off button again.
▶ Clean the retaining lug and
re-insert the battery.
▶ Remove the saw blade and refit
it correctly.
▶ Contact Hilti Service.
follow this link:
2373403
*2373403*