Operation - Hilti NURON SC 6WP-22 Manual

5.13 Setting product on guide rail
1. Place the product with the groove in the base plate on the guide rib.
2. Check the play between guide rail and base plate.
3. Adjust play by turning the eccentric screws (1):
▶ To reduce play, turn the eccentric screws clockwise.
▶ To increase play, turn the eccentric screws counter-clockwise.
4. Adjust play to the minimum at which the gliding movement is not impaired.
6

Operation

Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on or off
Switching on
1. Push the switch-on interlock up and hold it in this position.
2. Press and hold down the on/off switch.
3. Release the switch-on interlock.
The switch-on interlock remains in the disengaged position as long as you hold down the on/off
switch or the plunge unit is in a plunge position. The switch-on interlock automatically snaps to the
engaged position when the plunge unit is in the basic position and you release the on/off switch.
Switching off
4. Return the plunge unit to the basic position.
5. Release the on/off switch.
6.2 Dust and chips management
• Sawing with dust extractor:
Connect the suction hose to the dust removal connector and follow the instructions in the operating
instructions for the dust extractor.
• Sawing with dust bag:
Connect the dust bag with the adapter to the dust removal connector for dust extractor.
You can also operate the product without dust extractor or dust bag. Make sure that sawdust and
chips can be ejected without obstruction.
6.3 Sawing along a line
Saw only flat workpieces that offer a big enough contact surface to accommodate the whole of the
base plate.
1. Secure the workpiece to prevent movement and mark the line of cut (cutting mark).
*2373403*
11
2373403 English 13