Troubleshooting; Disposal; Manufacturer's Warranty - Tools; Declaration Of Conformity - Hilti WSC 255 Operating Instructions Manual

9. Troubleshooting

Symptom
The tool doesn't start
en
Tool doesn't produce full
power
No / reduced suction power

10. Disposal

Return waste material for recycling.
Most of the materials from which Hilti power tools
are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many
countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your
Hilti customer service department or Hilti sales represen-
tative for further information.
Only for EU countries
Disposal of electric tools together with house-
hold waste is not permissible!
In observance of European Directive 2002/96/EC on waste
electrical and electronic equipment and its implementation
in accordance with national law, electric tools that have
reached the end of their life must be collected separately
and returned to an environmentally compatible recycling
facility.
11. Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
24
Printed: 07.07.2013 | Doc-Nr: PUB / 5071324 / 000 / 00
Possible cause
Fault in the electric power supply
Defective supply cord or plug
Switch defective
Cross-section of the
extension cord is inadequate
Chip ejector channel blocked
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
12. EC declaration of conformity
Description:
Designation:
Year of design:
We declare, under our sole responsibility, that this prod-
uct complies with the following directives and standards:
2004/108/EG, as of 28.12.2009 98/37/EC, as of 29.12.2009
2006/42/EC, EN 55014-1, EN 55014-2, EN 60745-1, EN
60745-2-5, EN 61000-3-2, EN 61000-3-3
Hilti Corporation
Peter Cavada
Head Process & Quality Management
Business Area
Electric Tools & Accessories
02/2006
Possible solution
Plug in another electric tool and
check whether it starts.
Have it checked by an electric
specialist and replace if necessary.
Have it checked by an electric
specialist and replace if necessary.
Use an extension cord of adequate
cross-sectional.
See section «Preparation for use»
Clean out the chip ejector channel.
Hand-held circular saw
WSC255/WSC265
Dr. Heinz-Joachim Schneider
Executive Vice President
Electric Tools & Accessories
2000
Business Area
02/2006