Safety Measures - Vitek VT-1336 Manual Instruction

HAIR STRAIGHTENER VT-1336
The unit is intended for hair straightening.
DESCRIPTION
1. Display
2. Heating plates
3. Temperature increase button «+»
4. Temperature decrease button «-»
5. ON/OFF button «
6. Heating plates lock
7. Power cord
8. Hanging loop
ATTENTION! Do not use this unit near containers filled with
water (such as a sink, bath etc.).
•
When using the unit in a bathroom, unplug it right after usage
by taking the power plug out of the mains socket, as close-
ness of water is dangerous even if the unit is switched off.
•
For additional protection you can install a residual current
device (RCD) with nominal operation current not exceed-
ing 30 mA into the bathroom mains; contact a specialist
for installation.
•
Do not put the operating unit on any surface, but hang
it on the loop (8) instead. Make sure that the heating
plates and outer operating surfaces do not touch fusible
and inflammable objects (plastic, polyethylene, synthetic
materials etc.).

SAFETY MEASURES

Before using the unit, read this instruction manual carefully.
Keep this manual for future reference.
Use the unit for intended purposes only, as specified in this
manual. Mishandling the unit can lead to its breakage and
cause harm to the user or damage to his/her property.
•
Before switching the unit on, make sure that the voltage
of the mains corresponds to the unit operating voltage.
•
Never leave the operating unit unattended.
•
Do not switch the unit on in places where aerosols are
sprayed or highly inflammable liquids are used.
•
Hair spray should be applied only after hair straighten-
ing is finished.
•
Always unplug the unit immediately after usage and before
cleaning.
•
When unplugging the unit, pull the plug but not the cord.
•
Do not touch the power plug with wet hands.
•
Do not hang or keep the unit in places where it can fall
into a bath or a sink filled with water; do not immerse
ENGLISH
»
11