Safety Measures - Vitek VT-1335 Manual Instruction

HAIR STRAIGHTENER VT-1335
The unit is intended for hair straightening and curling.
DESCRIPTION
1. Heating plates
2. Power indicator
3. Power switch/temperature control knob
4. Handle
ATTENTION!
Do not use this unit near containers filled with water (such
as a sink, bath etc.).
•
When using the unit in a bathroom, unplug it right after
usage by taking the power plug out of the mains socket,
as closeness of water is dangerous even if the unit is
switched off.
•
For additional protection you can install a residual cur-
rent device (RCD) with nominal operation current not
exceeding 30 mA into the bathroom mains; contact a
specialist for installation.
•
Place the hair straightener on a flat steady heat-resistant
surface. Make sure that the heating plates and outer
operating surfaces do not touch fusible and inflammable
objects (plastic, polyethylene, synthetic materials etc.).

SAFETY MEASURES

Before using the electrical unit, read this instruction manual
carefully and keep it for future reference.
Use the unit for its intended purpose only, as specified in
this manual. Mishandling of the unit may lead to its breakage
and cause harm to the user or damage to his/her property.
•
Before switching the unit on, make sure that voltage of
the mains corresponds to unit operating voltage.
•
Never leave the operating unit unattended.
•
Do not switch the unit on in places where aerosols are
sprayed or highly flammable liquids are used.
•
Hair spray should be applied only after hair straighten-
ing is finished.
•
Always unplug the unit immediately after usage and
before cleaning.
•
When unplugging the unit, pull the plug but not cord.
ENGLISH
3