Vitek VT-1360 Manual Instruction page 22

ENGLISH
– Apply one-two drops of oil (10) on the blades (1) teeth
(pic. 8) and on the back side of upper blade, switch
the hair clipper on and make sure that the blades are
moving smoothly.
– Switch the hair clipper off, clean the excess oil with
a dry cloth.
– When you switch the hair clipper on, the indicator
"lubricating oil" «
display (12). It is a reminder to lubricate the clipper
blades before operation. If during operation (after
approximately 30-40 minutes) the indicator «
starts flashing again, lubricate the blades again.
Attention! Use only the oil (10) supplied with the set.
DO NOT USE vegetable oil, fat, oil mixed with any sol-
vents for lubricating. Solvents will evaporate, leaving
thick grease that may slow down the blades' motion.
Cleaning the hair clipper
– Switch the hair clipper off and unplug it.
– Clean the blades (1) from the cut hair using the clean-
ing brush (11).
– Wipe the accessories and the hair clipper body (3)
with a slightly wet cloth, and then dry them with a
soft cloth.
– Do not immerse the hair clipper into water or other
liquids.
– Do not use solvents or abrasives for cleaning the hair
clipper body.
Caution! Never wash the unit under running water! Use
the brush supplied with the unit for cleaning.
STORAGE
– Clean the hair clipper and lubricate the blades (1)
with oil (10) before taking it away for storage.
– Keep the hair clipper in a dry cool place out of reach
of children and disabled persons.
On/off button locking function
To prevent accidental pressing of the on/off button (4)
(for example, during transport in luggage), use the lock
function of the on/off button (4). To activate this func-
tion, press and hold the button (4) for 3 seconds. The
lock function will be activated and the clipper will stop
» will flash 3 times on the LED
22
»