Vitek VT-1360 Manual Instruction page 18

ENGLISH
will show the charging level «100». With the fully charged
battery, the hair clipper can operate for approximately
3.5 hours.
The battery of the hair clipper reaches its optimal capac-
ity after three cycles of charging and discharging. For
subsequent charging, 2-3.5 hours will be enough. To
ensure long battery life, the battery should be fully dis-
charged before the next charge. If the indicator «
flashes when the hair clipper is running on battery power
(when the battery charge drops to 10% or less), it means
that you'll have to recharge the battery soon.
BEFORE THE FIRST USE
In case of the unit transportation or storage at low
temperature keep it for at least three hours at room
temperature.
– Remove all advertising stickers and packaging ele-
ments that can prevent the unit operation.
– Check the unit for damages; in case of damages do
not use the unit.
– Before plugging the unit in make sure that the oper-
ating voltage of the unit corresponds to the voltage
of your mains.
Blades (1)
– The blades (1) are consumables and they are not cov-
ered by the warranty.
– The consumer should check the condition of the
cutting edges of the blades by themselves, as the
sharpening (polishing) of cutting edges is not cov-
ered by warranty.
– If the blades (1) have been removed for cleaning or
replacement, install them back, adjust and tighten
the fastening screws.
Taper lever (2)
– When you cut hair without using attachments (5, 6,
7, 8), you can shift the blade to adjust the cutting
length (pic. 1).
– In the upper taper lever (2) position haircut will be
the shortest.
18
»