Related Manuals for Elwa HOTRUN X24
Summary of Contents for Elwa HOTRUN X24
- Page 1 HOTRUN X24 Electric Instantaneous Water Heater Installation & User Manual Keep this instructions manual in a safe place once your unit is installed, you may need to refer to it for general instructions or future maintenance. - 1 -...
-
Page 2: Safety Instructions
If the electrical supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons authorised by Elwa to avoid a hazard. 4. This water heater is not intended for use by person/s (including children) with reduced physical, sensory, intellectual capabilities or lack of experience and knowledge unless the person/s –... -
Page 3: Table Of Contents
Product Features ELWA Hotrun water heaters are manufactured with patented heating technology incorporating multiple safety devices. The Hotrun X24 has the following features: 1. Instantaneous heating for on demand hot water, no pre-heating, no stand-by losses. This feature can save 60-70% power consumption compared to storage type water heaters. - Page 4 General Installation Guidelines. The installation must be compliant with the local electrical and plumbing standards. 1. Please make sure the main power supply circuit breaker, water pressure, earth connection, cable & wire size meet the installation requirements. 2. The water heater MUST always be connected to an uninterrupted solid earth connection directly from to the main earth connection in the switchboard.
- Page 5 Entry power cord/cable Fig 3: If you need to replace the supplied flexible power cord by hard wiring, remove the supplied flexible cord, use the rubber grommet (adjust to the required size) for the new power cable to be used. Pass the cable through the rubber grommet and terminate the wires firmly to the terminal block.
- Page 6 Water connections 1. The HOTRUN X range of water heaters can be connected to a mains cold water supply with a pressure of minimum 60KPa and maximum of 1.2MPa. On a rainwater supply the water must be filtered and have a constant and stable pressure & flow rate to avoid temperature variations during use.
-
Page 7: Electrical Connections
Fig 5-A: Concealed installation Use the 2 supplied stainless steel flexible hoses. Internally to connect the hot & cold-water pipes coming out from the wall Fig 5-B: Surface installation Fig 6: Put front cover back onto the heater Electrical connections 1. - Page 8 Electrical Diagram. Technical Specifications. Hotrun X24 3-Phase power connection (no neutral wire required) Dimensions 480 x 240 x 120 mm Power rating 12kW / 18kW / 24kW Voltage 415 V Current 3 x 16 / 3 x 25 / 3 x 35 Amps...
- Page 9 Operating Instructions. 1. Run the water for a few minutes until water flow is continuous and all air is purged from the pipework and the water heater before activating power supply. 2. After the power supply has been turned on the water heater will beep; the display will illuminate for 2 seconds and Hotrun will enter a standby mode.
-
Page 10: Components
Components. Note: Do not attempt to repair this water heater yourself. Call a licensed service person for assistance. Always shut off the power supply while performing maintenance. Accessories supplied: X24 Water Heater 4 Fiber washers, 2 flexible hoses, plugs and screws Operation and Installation instructions, wall template Approval Standards: IEC/AS/NZS 60335.2.35 &... -
Page 11: Warranty
Hotrun is located, providing a signature agreeing & accepting the terms should request for service be proven to not be a Elwa product fault but an installation fault. In that case a call-out fee and labour costs can be charged to the person making the request. -
Page 12: Correct Disposal Of This Product
© Copyright to Elwa Group of companies, nothing from this manual can be reproduced by others without written permission from Elwa Pty Ltd Australia. This manual has been made with care, Elwa holds the right to adjust products in the future for various reasons.