Advertisement
Entry power cord/cable
Fig 3:
If you need to replace the supplied flexible power cord by hard wiring, remove
the supplied flexible cord, use the rubber grommet (adjust to the required size) for the
new power cable to be used. Pass the cable through the rubber grommet and
terminate the wires firmly to the terminal block. Terminate the power cable to the
terminal blocks with L1, L2, L3 and Earth wires as indicated.
Mounting instructions
Mark the holes for wall mounting using the supplied template, drill the holes
Fig 4:
with Ø6mm wall plugs and fit the mounting bracket to the wall.
Install the mounting bracket on the wall according to the template supplied.
Slide the water heater onto the bracket and secure with the bottom screw inside the
bottom compartment.
- 5 -
Advertisement
