Electric and digital controlled water heaters (10 pages)
Summary of Contents for Elwa HOTRUN 35
Page 1
Operating & Fitting Instructions Domestic & Commercial Applications HOTRUN 35-90 ELECTRIC INSTANTANEOUS WATER HEATERS saving water and energy...
7 . Red marking = hot water outlet General information The ELWA Hotrun electric instantaneous water-heaters are designed for point of use (most efficient and lowest water and energy consumption) and multipoint applications, such as a wash basin or shower (or both), in fact all places where instant hot water is required . The heating of the water is started instantly by opening a tap or valve connected to the hot water outlet .
Technical specifications Model Rating (kW) 3 . 5 4 . 6 6 . 0 7 . 2 9 . 0 Current (A) 2x16/32 2x20/40 Minimum pressure for all models: 1 bar / 100 kPa Maximum pressure for all models: 10 bar /1MPa Guaranteed Flow Rates at 37°C outlet temperature l/min when 1 .
Mounting instructions The screws and plugs are supplied with the unit . 1 . Mark the position of the plugs according to the positional template allowing enough space around the Hotrun to open the Hotrun by removing the top and bottom screws if needed after installation .
Page 6
Point of use installation mains pressure Point of use installation Multipoint installation...
Electric connection 1 . Australian and New Zealand Standards wiring rules and guidelines must be adhered to . In most situations the installation of a 2-phase supply will be required for the Hotrun 72 and 90, to avoid voltage drop on a single phase supply/connection . 2 .
Initiation Attention: Avoid overheating Fill the unit completely with water before plugging it in or turning on the mains power supply . For that purpose: Open the tap and wait until the water flows out from the spout without any air bubbles . Close the tap .
Page 9
- Remove all restrictors in the tap or aerator and use ‘star’ inserts in spout instead of aerator . Allowing full flow will often help in low pressure situations . If the tests above indicate a fault then contact Elwa Technical Support...
Technische gegevens Terms of warranty On the provision that the installation instructions have been followed, Elwa gives a warranty of two years on the Hotrun . The warranty starts at the date of purchase . If despite our extensive products control complaints arise, you should inform your installer .
Page 11
Flexible hose instructions For the range with built-in flow control: 1.9 l/min 2.5 l/min 3.0 l/min 4.0 l/min 5.0 l/min hotrun hotrun hotrun hotrun hotrun...