Jamr Technology BC31L User Manual page 9

Trouble removal
Problem Check
Check the battery power
No power
Check the polarity position
Whether the plug insert
No inflation
Whether the plug broken or leak
Whether move the arm when inflate Keep the body peaceful
Err and stop
working
Check if chatting when measured
Cuff leak Whether the cuff wrap too loose
Whether the cuff broken
Please contact the distributor if you can't solve the problem, do not
SYMBOL DESCRIPTIONS
The following symbols may appear in this manual, on the Digital Blood
Pressure Monitor, or on it's accessories. Some of the symbols represent
standards and compliances associated with the Digital Blood Pressure
Monitor and its use.
Authorized Representative in the European Community
Device Directive 93/42/EEC.
Date of manufacture.
Manufacturer
Specifies serial number
Type BF applied part
Direct current
DISPOSAL: Do not dispose this product as unsorted municipal
waste. Collection of such waste separately for special treatment
is necessary.
Follow instructions for use
Cause and solutions
Replace new one
Installation for proper placement
of the batteries polarities
Insert into the air socket tightly
Change a new cuff
Wrap the cuff tightly
Change a new cuff
Medical device
Put up
Fragile
Afraid of the rain
Fear of the sun
IP21
Handle gently
Temperature range
Mode of operation: continuous
5.6. Memory
Each unit stores 120 sets measurements for 2 users,totally 240 sets (User 1
and 2).Measurements for each user are stored separately. Be certain that
you are viewing the measurements for the correct user.
A.View the memory
With the unit off, press the Memory button. The monitor will display User ID
and an average value of the last 3 times measurements stored in the unit.( If
measurements are less than 3 sets, directly display the first set )
Each time you press the Memory button, it will display the memory value from
the latest to the oldest in turn.
Each time you press the Users button, it will display the memory value from
the oldest to the latest in turn.
B.Delete memory:
In average value memory viewing mode,the average value symbol (
being displayed, long press the (MEM) button for 3 seconds ,then it will delete
all measurements for the current user.
In single set memory viewing mode,long press the (MEM) button for 3 seconds
,then it will delete only a set measurement being displayed.
) is