Using Your Monitor For The First Time - Jamr Technology BC31L User Manual

4. Using your Monitor for the First Time

4.1 Battery Power checking
The battery is built-in chargeable Lithium battery.
Press the START/STOP button, if the Low battery symbol is blinking and the
device speaks "battery low power, please recharge it" . It means the battery
power is low and you cannot take any further measurements,it need tobe
recharged.
During the charging process, the charging indicator on the display screen
blinks. When the charging indicator stops blinking. it means the battery
power is fully recharged.
4.2. System Settings
Before setting, ensure that the battery power is enough.
A.Setting the voice.
In some states that need to play voice, the voice can be turned on or off by
pressing the ( ) button.
Picture-04
B.Setting the User ID(1 or 2):
With the unit off,Press the Users button and then you can set the User ID user
by pressing the Users button.
C.Setting the User ID/Year/Month/Date/ hour system/Time/Volume:
With the unit off,Long press the Memory button for more than 3s, and then you
can start to set.
Setting the Year:
When the year display is flashing, press the Users button continuously and it
will increase continuously 1 by 1 until 2049, and then return the original year,
press the Mute button continuously and it will reduce continuously 1 by 1, once
the year set is OK, press the Memory button to confirm.
Setting Month/Date:
Initial Month/Date is 1/01, when the Month display is flashing, press the
Users button continuously, the month will increase continuously 1 by 1 ,press
the Mute button continuously and it will reduce continuously 1 by 1, press the
Memory button to confirm, and do in the same way to set the date, press the
Memory button to confirm.
Setting hour system：
Initial hour system is 12 hour ,press the Users button or Mute button and
then you can switch 12 or 24 hour system ,press the Memory button to
confirm.
Setting Time :
When the hour display is flashing, press the Users button continuously, the
hour will increase continuously 1 by 1, press the Mute button continuously and
it will reduce continuously 1 by 1,press the Memory button to confirm, and do
in the same way to set the minute. Press the Memory button to confirm.
Setting Volume:
When display with VOL is flashing, press the Users button or Mute button to
switch volume 1,volume 2, volume 3 or OFF. Press the Memory button to
confirm.After the setting is completed, the device switches off automatically
and save the setting result.
4.3. Cuff tube connection
Insert the cuff tube into the opening on the left side of the monitor ( As shown
in picture-05)