Installing The Vac-Bagger Onto The Tractor - Toro 79161 Operator's Manual

3. Secure the upper half of the gusset to the rear support
rod with 4 bolts (1/4 x 1-3/4 in.), 8 washers (1/4 in.),
and 4 locknuts (1/4 in.) (Fig. 17).
4. Slide the bottom of the quick-attach bracket down into
the hole in the hitch and hook the notches over the rear
support rod (Fig. 17).
5. Slide the hairpin cotter through the hole at the bottom of
the quick-attach bracket (Fig. 17).
6. Attach the plates to the quick-attach bracket using 4
bolts (1/4 x 3/4 in.), 4 washers (1/4 in.), and 4 locknuts
(1/4 in.) (Fig. 17).
Installing the Vac-Bagger onto
the Tractor
Installing the Bagger Assembly
1. Carefully lift the bagger top and slide it onto the
quick-attach bracket (Fig. 18). The bagger top is easier
to install if two people work together.
1
2
Figure 18
1. Bagger top
m–5303
2. Quick-attach bracket
11
Caution
If you remove the spring-loaded bagger top when
it is closed (in the down position), the top may
suddenly fly open and you or someone else may be
bruised, pinched, or injured in another way.
Always open (raise) the bagger top before you
remove or install it on the quick-attach bracket.
2. Install the bags by sliding the bag frame hooks onto the
retaining brackets (Fig. 19).
Figure 19
1. Bag frame hook
3. Lower the bagger top onto the bags. Then push down
on both bag retainer handles until they lock on the bag
frame (Fig. 20).
1
2
Figure 20
1. Bagger top
4. Move the tractor seat to its normal position.
1
2
1373
2. Retaining bracket
1376
2. Bag retainer handles