Table of Contents
Advertisement
G010578
Figure 11
1. Support bracket
3. Install the angled bagger bracket to the engine guard
using two carriage bolts (5/16 x 3/4 inch) and two
locknuts (5/16 inch).
G014882
4
Figure 12
1. Carriage bolt (5/16 x 3/4
inch)
2. Angled bracket
4. Install the bagger frame to the support bracket. Secure
the bagger frame with a clevis pin (1/2 x 2-1/4 inch)
and hair pin cotter (Figure 13).
1
2
2. Self tapping screws (5/16
x 3/4 inch)
1
2
3
3. Lock nut (5/16 inch)
4. Hole in engine guard,
existing
5
G014884
1. Bagger frame
2. Clevis pin (1/2 x 2-1/4
inch)
3. Support bracket, receiver
5. Install two support rods, one to each side of the bagger
frame. Locate the existing keyed slot in the machine
frame and install the bent, flared end of the rod into
that slot (Figure 14). Move the rod rearward to seat
it in the frame.
G014885
Left side shown
1. Washer
2. Hair pin
3. Bracket frame hole
6. Insert the bent ends of the rod into the bagger frame
as shown in Figure 14. Secure the end of the rod with a
washer and hair pin.
9
3
4
Figure 13
4. Hair pin
5. Angle bracket
2
1
3
4
5
6
Figure 14
4. Support rod
5. Keyed slot, existing
6. Bent, flared end of support
rod
1
2
Advertisement
Table of Contents
