Battery - BMW Motorrad R 1250 RT special vehicle 2018 Rider's Manual

Table of Contents

Advertisement

Remove protective cap 1.
Connect the red jump lead to
the positive battery connection
point 2 of the drained battery
and the positive terminal of the
donor battery.
Then connect one end of the
black jump lead to the negative
terminal of the donor battery
and the other end to negative
terminal 3 of the discharged

battery.

Run the engine of the donor
vehicle during jump-starting.
Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a few
minutes before repeating the
attempt in order to protect the
starter motor and the donor

battery.

Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminals first,
then disconnect the second
lead from the positive termin-
als.
NOTICE
Do not use proprietary start-as-
sist sprays or other products to
start the engine.
Install the protective cap.
Installing the battery cover
(
181).
Battery
Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential if
warranty claims are to be con-
sidered.
Compliance with the points be-
low is important in order to max-
imise battery life:
Keep the surface of the battery
clean and dry.
Do not open the battery.
Do not top up with water.
Be sure to read and comply
with the instructions for char-
ging the battery on the follow-
ing pages.
Do not turn the battery upside
down.
8
177
z

Advertisement

Table of Contents
loading

Table of Contents