Table of Contents
Advertisement
C.5 Control Head Setup
The control head has several configurable parameters, as shown in
figure C-6 below. The default settings will generally provide excellent
performance for most boats.
Access the parameters by double-clicking on the Main Control Head
in the Datalink interface list, then clicking on the Parameters tab. A
reset function is provided so that default values can be restored at
any time. Remember to click Write after making any changes.
Figure C-6. Control Head setup.
The functions of these parameters are as follows:
One Lever Sync Mode – Controls the throttle behavior when the Power
Train Sync (PTS) feature is engaged. When set to RPM the control
system will use engine RPM feedback to match engine speeds. (An
engine RPM source is required – see section 3.6.) When set to Throttle
the control system will simply match the throttle command.
Two Lever Sync Enabled – When Two Lever Sync is enabled the control
system will synchronize engine speeds when both levers are in close
to the same position. This feature requires an engine RPM source
(see section 3.6).
Two Lever Sync Window – This parameter sets the maximum throttle
difference for which Two Lever Sync will function.
Forward/Reverse Trolling Mode – sets the maximum percentage of
wide open throttle when trolling mode is engaged. A forward setting
of 50% means that when the throttle lever is fully forward the throttle
is limited to 50% of maximum. This provides greater throttle sensitivity
when moving at slow speeds.
C-9
Advertisement
Table of Contents
