Dometic i7800 Installation Manual page 27

Procedure
1. Turn ignition on but do not start engines.
2. Navigate to Dealer Menu > Initial Setup > Shift & Throttle >
Adjust Port Throttle Actuator.
3. Increase the port control lever to the full throttle position
(forward gear) and verify that the throttle linkage reaches the
wide open throttle (WOT) position.
4. Increase the stroke parameter as necessary to reach the WOT
position. Press Save after each adjustment to have it take effect.
5. Tighten the rod end lock nut (refer to the i7X00 installation manual).
You will need to apply Loctite
this after verifying performance in the sea trial.
6. Repeat this procedure for the starboard throttle actuator.
7. The Idle Offset parameter is used to fine tune throttle response
and to synchronize the throttle actuation.
a. On some engines it may take a large amount of lever travel
before RPM starts to increase. You can reduce this deadband
by increasing the Idle Offset parameter or by adjusting the rod
end position.
b. When both levers are advanced at the same time both engines
should start to increase RPM simultaneously. If they do not you
can adjust the Idle Offset parameter until they are synchronized.
EVINRUDE
SHIFT SETTINGS
Shift to Forward Pull
Forward Stroke 32
Reverse Stroke 32
THROTTLE SETTINGS
Acceleration Push
Direction
Throttle Stroke 62
Table 4-1. Typical settings for mechanical engines. Verify before use.
® 242 to the threads, but you will do
HONDA MERCURY SUZUKI
Pull Pull Pull
32 34
34
32 34 34
Push Pull Push
62 58 70
YAMAHA YANMAR
Pull Varies
32 32
32 32
Push Pull
52 54
4-5