Table of Contents
Advertisement
WARNING
MALE
TERMINATOR
CM10051
OPTIONAL
THIRD STATION
CONTROL HEAD
3' PIGTAIL
FEMALE
TERMINATOR
CM10052
CM10060
Figure 3-4. CAN2 wiring diagram, triple station, twin engine.
3-6
3.5 CAN2 Harness Connections
Figure 3-4 and figure 3-5 show the CAN2 network wiring for single
and dual station applications. All tees must be secured using both
screw holes, and the cable drops at each tee must be appropriately
secured and strain-relieved to prevent any pull on the tees. See
figure 3-6 for proper tee installation example.
The CAN2 network must contain two, and only two, terminating
resistors. One terminator should be installed at each end of the
network backbone.
FAILURE TO SECURE HARNESS MAY RESULT IN HARNESS WEAR,
CAUSING LOSS OF THROTTLE CONTROL, PROPERTY DAMAGE,
PERSONAL INJURY AND/OR DEATH.
SHIFT/THROTTLE ACTUATORS
3' PIGTAIL
3' PIGTAIL
2 x NETWORK TEES CM10060
OPTIONAL
SECOND STATION
CONTROL HEAD
3' PIGTAIL
CM10060
CANtrak SETUP
TOOL EPSK1207
CM20029
TEMPORARILY
INSTALLED
MAIN STATION
CONTROL HEAD
3' PIGTAIL
CM10060
Advertisement
Table of Contents
