Table of Contents
Advertisement
3.0 INSTALLATION
3.1 Important Information/Technical
Support Contact
To assist with the installation and maintenance of this Electronic Shift
and Throttle system Dometic recommends that:
• Installation MUST be performed by a Dometic authorized installer.
• Read and understand ALL installation manuals before starting
the installation process. Knowing the correct order of installation
and location of components will drastically reduce installation
time as well as prevent common installation errors.
• Read and understand ALL Safety Information that is noted in
this manual and ALL other Installation Manuals.
If any problems are found before, during or after the installation of the
steering system, please contact Technical Support for assistance:
Technical Support
Web:
www.dometic.com
E-mail: seastar@dometic.com
Phone: 604.248.3858
3.2 Installing the Control Head
Mount the control head on the dash in an area which will allow for
convenient access during use. Whenever possible, it should be
mounted in a location to minimize water spray. Ensure that the control
handle(s) can be moved throughout the complete range of motion
in both forward and reverse without interference. ABYC standard
P-14 calls for a minimum of 2-1/2" (64 mm) clearance between the
control lever and the steering wheel rim under all possible lever
and wheel positions.
The control head requires one of the dash cutout templates in
Appendix A.
3.2.1
Control Head Trim Switch Connection (Optional)
The control head includes a single trim/tilt switch on the end of the
port handle. This switch can be wired to provide synchronous trim/
tilt control of all engines. If independent trim/tilt is desired use tilt/
trim kit HA5491 (for twin engine configurations) and connect the
wiring as shown in Figure 3-1.
3-1
Advertisement
Table of Contents
