Yaesu FT-1000MP Operating Manual page 93

moc ae eee
TH Suber ec a
Sub VFO Receiver - Enables or disables the
SUB VFO-B receiver from operation. If disabled,
you can temporarily turn on the Sub receiver by
pressing bv], or the SUB VFO-B RX button/LED.
wl er -f
ees |
Remote Control Function- Selects the active
feature for remote control operation. Note - Re-
mote control operation requires a 12-switch input
keyboard for operation; see the description and
charts on pages 60-63 for details of operation.
Keyer - Activates contest keyer operation.
Function Keys - Emulate front panel Memory
Control keys.
VFO-A - Enables direct-frequency input to
VFO-A by emulating the front panel keypad keys.
VFO-B - Enables direct-frequency input to
VFO-B by emulating the front panel keypad keys.
a7
out
ASt -SEt
FAST Button Operation - Selects front-panel
FAST button actuation:
Momentary - Press and hold to engage fast
tuning.
Continuous - Toggle on/toggle off fast tuning.
LOCK Button Operation - Chooses between
Dial- Locks MAIN VFO-A knob only
Panel - Locks front panel buttons & keys (refer
to drawing below).
Primary - \ocks front panel primary function
keys (refer to drawing below).
Es : : (omme)
allo
i OL Joo
Panel Lock - when the Main VFO (A) lock is pressed, all
controls within the shaded area are disabled.
When the Sub VFO (B) lock is pressed, only the SUB VFO
tuning knob is disabled.
© 0| Ofa87 BaeCO Oe °
Xe) olf EG) Ols ,O
OC)0 00 (EEO So
Primary Lock - when the Main VFO (A) lock is pressed, only
the MAIN VFO tuning knob is disabled.
When the Sub VFO (B) lock is pressed, all controls within
the shaded areas are disabled.
Menu Programming - Selection & Settings
Split Mode Operation - Selects one of three
split operating modes:
Normal - |n this default mode, pressing [Put]
activates SUB VFO-B for transmission. Other set-
tings (Such as mode and frequency) must be
manually set for the Sub VFO.
Auto - When [sett] is pressed, SUB VFO-B is
enabled for transmit, and the selected operating
mode from MAIN VFO-A is automatically copied
into SUB VFO-B.
A=B - Same as Auto mode above; however, a
preset frequency offset is applied to SUB VFO-B
for transmission (see Menu 1-6: Quick Split).
Receiver Front-End RF Amplifier - Selects
the desired receiver front-end amplifier configura-
tion:
Flat - A broadband amplifier with flat response.
Tuned - A separate tuned amplifier for low and
high bands.
Antenna Selection - Chooses between:
AUTO - Antenna selections are automatically
copied along with other operating parameters
during memory programming.
ON - Enables front panel ANT switch.
OFF - Disables the front panel ANT switch (only
ANT-A is selected).
User Setting - This configures an operating
"environment" selected by pressing the front-
panel USER button. Operating parameters are se-
lected using the SUB VFO-B knob, while options
are chosen with the MAIN VFO-A knob.
Mode - This selects to which mode the custom
settings are applied. Choose LSB, USB, CW (nor-
mal/reverse), RTTY (normal/reverse), or packet
(LSB only).
Display Offset - You can choose a custom off-
set +5.000 kHz (in 5-Hz steps) to take effect when
the User mode is active. The default offset is
dependent upon operating mode.
page 91