Tuning Knob Torque Adjustment - Yaesu FT-1000MP Operating Manual

Installing Internal Accessories
Tuning Knob Torque Adjustment (Turn the exposed shaft tension spring counter-
clockwise to loosen the torque, or clockwise to
If the tuning knob is too tight or too loose for tighten.
your preference, and if you have a 2-mm (%a4') Soe
Allen wrench, you can adjust the torque.
OPull the knurled rubber ring off of the tuning siti
loosen
knob. :
YQ
Tighten
Replace the knob, tighten the set screw, and
replace the rubber ring.
Locate the hole in the edge of the tuning knob,
and use the Allen wrench to loosen the set
screw accessible through the hole, just enough
to allow the knob to be pulled off the shaft.
Setting:
page 102