Rear Panel Controls & Connectors - Yaesu FT-1000MP Operating Manual

General Information
Rear Panel Controls & Connectors
1 16 17 18 19 20 21 22 23 24
fl CO
il |
- WIWte JLJIU4
ARnOROKOKOK9R0,0-0R0
02626252826252526 0698 ®@
OG 082825252528 25 26505
62826282528 0525 08960
6202626202626 2626262 @
oPOS OR OVER GR ORGROSO
SokosoP neo OsOROR0R0 sino ok ne a
, © © ae © © ©=
® °o®@
REMOTE OW «i ps Ove? PAGED PTT rt PATCH SPKR AF OUT
( D) 2 ©9000 wo -@e
|_| (3 ye ae
& | mY)
23 4 5 6 7 8 9 1011 12 13 14 15
(1) ANT Coaxial Jack
Connect your main antenna here, using a type-
M (UHF, PL-259) plug and coaxial feedline. This
antenna is always used for transmission, and is
also used for reception unless a separate receive
antenna is also used for the main receiver. The
internal antenna tuner affects only the antenna
connected here, during transmission.
(2) REMOTE Jack
By plugging in a remote control keypad here,
direct access to the FT-1000MP CPU is provided
for control functions such as contest memory key-
ing, frequency, and functions control.
(3) CW SIDETONE Control
Insert a small insulated screwdriver here and
turn the trimmer inside to adjust the volume of the
side tone heard when the SPOT button or CW key
is pressed.
(4) KEY 3-Contact Phone Jack
This 1/4-inch phone jack accepts a CW key or
paddle manipulator. It is connected in parallel with
the jack with the same name on the front panel
(either or both may be used). A 2-contact plug
cannot be used in this jack. Keyup voltage is +5
V, and keydown current is 0.5 mA. Plug wiring is
shown on page 4.
(5) BACKUP Slide Switch
Keep this switch in the ON position to retain all
memory and VFO settings during power-off peri-
ods. There is no need to turn this switch off unless
you plan to store the transceiver for a long period
without use.
(6) CAT Serial DB-9 Jack
This 9-pin serial DB-9 jack allows external
computer control of the FT-1000MP. Connect a
serial cable here and to the RS-232C COM port
on your personal computer. CAT command proto-
col and data formats are described in the CAT
chapter, starting on page 73.
(7) Dvs-2 DIN Jack
This 7-pin input/output jack is for connection of
the DVS-2 Digital Voice Recorder option, des-
cribed on page 64.
(8) PACKET DIN Jack
This 5-pin input/output jack provides receiver
audio and squelch signals, and accepts transmit
(AFSK) audio and PTT control, from an external
Packet TNC. Pinout is shown on page 53. The
receiver audio level at this jack is approximately
100 mV (@600Q), preset by VR3010 on the AF
Unit (see page 53 for how to gain access to this
trimmer, if necessary).
page 19