Using The Remote Transmitter; Remote Engine Control - CrimeStopper COOL START RS-900 Operating Instructions Manual

The transmitter supplied with the RS-900 system
has six buttons. The button configuration of the RS-
900 is Factory-set and unchangeable. The RS901
model does not include remote transmitters, as it is
designed for the expansion of a "parent" remote
keyless or alarm system. See Page 11 for additional
information on how to use your remote to operate a
second vehicle equipped with an RS-900 system.
NOTE: BUTTON #4 Remote Start
There is a deliberate delay built into the system on
button #4 to help prevent accidental remote starting
from the remote being in your pocket or purse.
During normal use, if you press button #4 too
quickly, the system may not start the engine.
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1 second. (For RS901 models, activate Green Start input wire.)
2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on.
3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be
turned off with remote transmitter by pressing and releasing the Start button. (For RS901 model, activate the
Green Start input wire.

USING THE REMOTE TRANSMITTER

REMOTE ENGINE CONTROL

FLASH 1X
IGN
THEN
SOLID
#1
LOCK
#3
TRUNK
COOLSTART
AFTER
4
STARTER
SEC.
3
#2
UNLOCK
#4
FLASHLIGHT
#6
VEHICLE 2
#4
REMOTE
START
SOLID