CrimeStopper CS-2011DP Installation Handbook page 6

Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)
This wire activates when the unlock button on the remote is pressed a second time within 15 seconds upon
disarming. This wire is used for the Optional Separate Driver's/Passenger Unlock feature. Connects to unlock
circuit for passenger door or doors. See DOOR LOCK WIRING for special configuration options.
Orange: (-) Negative Starter Disable/Anti-Grind Output
This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the
blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to an Orange wire on the relay socket. This output also turns on with remote start to function as an "Anti
Grind" wire to prevent the starter from grinding if you get in your car and turn the key too far after it was remote
started. See starter disable diagram on next page.
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
WIRING: 9-PIN Connector Cont.
STARTER DISABLE:
IGN. SWITCHED
STARTER WIRE
YELLOW
BLUE
BROWN
CUT
ORANGE
ORANGE
6
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!