Table of Contents
Advertisement
After adjustment, be sure to attach the plastic cap securely as shown in Fig. 11-2.
Opened
Fall Prevention
Insert the resin cap straight into the direction
shown in the figure so that it does not bite the
fall-prevention portion.
Always lock the resin cap. Also, make sure that the gasket seal
Turning the resin cap more than 90° may cause damage. Do not
< Fig. 11-2 >
WARNING
does not bite the fall-prevention portion.
The degree of protection may be impaired if the gasket seal is
not in close contact with the case.
apply excessive force (should be 50 mN·m or less).
Locked
Lock the resin cap by
turning it 90° clockwise
while pushing it lightly.
21
Gasket Seal
Do not bite the fall-
prevention portion.
TY-ZT11-004A Ver. 3
Advertisement
Table of Contents
