Setting Dynamike; Rf Meter; External Speaker; Pa (Public Address) - Cobra 25 LTD Owner's Manual

Operation
AM
FM
8

Setting Dynamike

®
This controls the microphone sensitivity
(outgoing audio level).
2. Initially, set fully clockwise so that the
maximum voice volume is available.
Dynamike may have to be reduced in
®
some conditions.
3. Push and hold the mic button to transmit.
When transmitting, hold the microphone
two inches from your mouth and speak in
a clear, normal voice. Release the mic
button to receive.

RF Meter

This meter swings proportionately
to the RF output (outgoing signal) while
transmitting.

External Speaker

Connecting an external speaker can provide
louder and clearer incoming audio.
Connect an external speaker to the
speaker jack on the rear panel.
NOTE: The external speaker should have
8-ohm impedance and be rated to handle
at least 4.0 watts. When the external
external
speaker is plugged in, the internal speaker is
automatically disconnected.
Cobra external speakers are rated at 10 watts.
Operation

PA (Public Address)

1. Connect an external PA speaker to the PA
jack on the rear panel.
NOTE: The speaker should have 8-ohm
impedance and be rated to handle at least
4.0 watts.
2. Set the CB/PA switch to the PA position.
NOTE: The speaker should be directed away
AM
from the microphone to prevent acoustic
FM
feedback.
3. Push and hold the microphone button and
speak in a normal voice. Your voice will
now transmit through the PA speaker.
4. Adjust the PA speaker volume with the
Dynamike
AM
FM
®
control.
9