Table of Contents
Advertisement
6
Maintenance and care
General information
Service life of the product will extend and the possibi-
lity of problems will decrease if the product is cleaned
at regular intervals.
DANGER:
Disconnect the product from mains supply
before starting maintenance and cleaning
works.
There is the risk of electric shock!
DANGER:
Allow the product to cool down before you
clean it.
Hot surfaces may cause burns!
•
Clean the product thoroughly after each use. In
this way it will be possible to remove cooking
residues more easily, thus avoiding these from
burning the next time the appliance is used.
•
No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean
the product and wipe it with a dry cloth.
•
Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is im-
mediately wiped dry.
•
Do not use cleaning agents that contain acid or
chloride to clean the stainless or inox surfaces
and the handle. Use a soft cloth with a liquid
detergent (not abrasive) to wipe those parts
clean, paying attention to sweep in one direc-
tion.
The surface might get damaged by some
detergents or cleaning materials.
Do not use aggressive detergents, cleaning
powders/creams or any sharp objects during
cleaning.
Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the oven door glass
since they can scratch the surface, which
may result in shattering of the glass.
Do not use steam cleaners to clean the
appliance as this may cause an electric
shock.
20/EN
Cleaning the hob
Cleaning the burner
1. Remove the pan supports, burner heads and
burner caps and clean them with a soft and
damp cloth.
2. Clean the dirt in burner chamber and on injector
with a soft and damp cloth and wipe them dry
with a dry cloth.
3. Use commercially available potassium stearate
(soft soap) for stubborn dust and dirt on the
burner heads.
4. Clean the burner plate of the hob.
5. Make sure that the burner heads are installed on
their correct places and seated tightly. Incorrect
installation will result with gas leakage, misfire or
irregular burning.
6. When fitting the pan supports, pay attention to
place the pan support feet so that the burners
are centered.
In case of any overflow, turn off the burner
immediately. Remove the pots and pan supports
on it. Clean the overflowed material with a dry
and absorbent cloth. Pay attention not to let
liquids enter into burners. Clean inside of the
burners as well if any liquid has entered. Do not
re-operate the hob before cleaning it.
Advertisement
Table of Contents
