Maintenance And Care; General Information - Beko HIML 95225 SXE User Manual

6

Maintenance and care

6.1 General information

Service life of the product will extend and the pos-
sibility of problems will decrease if the product is
cleaned at regular intervals.
Disconnect the product from mains
B
supply before starting maintenance
and cleaning works.
There is the risk of electric shock!
Allow the product to cool down be-
fore you clean it.
Hot surfaces may cause burns!
Clean the product thoroughly after each use.
In this way it will be possible to remove cooking
residues more easily, thus avoiding these from
burning the next time the appliance is used.
• No special cleaning agents are required for
cleaning the product. Use warm water with was-
hing liquid, a soft cloth or sponge to clean the
product and wipe it with a dry cloth.
• Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is im-
mediately wiped dry.
• Do not use cleaning agents that contain acid or
chloride to clean the stainless or inox surfaces
and the handle. Use a soft cloth with a liquid de-
tergent (not abrasive) to wipe those parts clean,
paying attention to sweep in one direction.
The surface might get damaged by
some detergents or cleaning mate-
rials.
Do not use aggressive detergents,
C
cleaning powders/creams or any
sharp objects during cleaning.
Do not use harsh abrasive cleaners
or sharp metal scrapers to clean
the oven door glass since they can
scratch the surface, which may re-
sult in shattering of the glass.
22 / EN
C
Do not use steam cleaners to clean
the appliance as this may cause an
electric shock.
6.2 Cleaning the hob
6.2.1 Cleaning the burner
1. Remove the pan supports, burner heads and
burner caps and clean them with a soft and
damp cloth.
2. Clean the dirt in burner chamber and on injector
with a soft and damp cloth and wipe them dry
with a dry cloth.
3. Use commercially available potassium stearate
(soft soap) for stubborn dust and dirt on the
burner heads.
4. Clean the burner plate of the hob.
5. Make sure that the burner heads are installed on
their correct places and seated tightly. Incorrect
installation will result with gas leakage, misfire
or irregular burning.
6. When fitting the pan supports, pay attention to
place the pan support feet so that the burners
are centered.
Built-In Hob / User Manual