Beko HIMW 95225 SXE User Manual page 15

If there is a built-in oven installed under the hob;
• Gas hose must be routed in a way that it will not
touch the oven, sharp edges or corners be-
neath the hob, or will not be kinked or twisted.
If you will make the gas connection from left
hand side when viewed from your position, fix
the hose with clamps.
1 Bottom view
2 Hose tip
3 Hose
4 Clamp
5 Oven
Installing the product
1. Remove burners, burner caps and grills on the
hob from the product.
2. Turning the hob upside down, place it on a flat
surface.
3. In order to avoid the foreign substances and
liquids penetrate between the hob and the coun-
ter, please apply the putty supplied in the packa-
ge on the contours of the lower housing of the
hob but make sure that the putty does not over-
lap.
4. Fill the corners by forming bends at the corners
as illustrated in the figure. Form as much bend
as required to fill the gap in the corners.
Make sure that the skirting sections on
the lower housing of the hob are filled
with putty.
5. Turning the hob again, align and place it on the
counter.
6. You can secure your hob to the counter by using
the clamp and the screws supplied.
1
Hob
2
Putty
3
Installation clamp
4 Counter
Thickness of the counter must be at least 40 mm.
When installing the hob onto a cabinet, a
shelf must be installed in order to separate
the cabinet from the hob as illustrated in the
above figure. This is not required when
installing onto a built-under oven. .
For example, if it is possible to touch the bottom of
the product since it is installed onto a drawer, this
section must be covered with a wooden plate.
* min. 25 mm
For counters with a thickness of 40-50 mm, install the
clamps as shown below.
You must leave a ventilation opening on the remain-
ing part in order to provide ventilation at the lower
part of the hob. In addition to being necessary for
component temperatures, this process is also com-
pulsory for the TC burner to take in air from the
bottom. It can be "100 cm 2 at least".
15/EN