Maintenance And Care General Information; Cleaning The Hob - Beko HIAG64223 SX-D-FICz User Manual

6 Maintenance and care
General information
Service life of the product will extend
and the possibility of problems will
decrease if the product is cleaned at
regular intervals.
Disconnect the product from
mains supply before starting
maintenance and cleaning works.
There is the risk of electric shock!
Allow the product to cool down
before you clean it.
Hot surfaces may cause burns!
• Clean the product thoroughly after
each use. In this way it will be possible
to remove cooking residues more
easily, thus avoiding these from
burning the next time the appliance is
used.
• No special cleaning agents are
required for cleaning the product. Use
warm water with washing liquid, a soft
cloth or sponge to clean the product
and wipe it with a dry cloth.
• Always ensure any excess liquid is
thoroughly wiped off after cleaning
and any spillage is immediately wiped
dry.
• Do not use cleaning agents that
contain acid or chloride to clean the
stainless or inox surfaces and the
handle. Use a soft cloth with a liquid
detergent (not abrasive) to wipe those
parts clean, paying attention to sweep
in one direction.
The surface might get damaged
by some detergents or cleaning
materials.
Do not use aggressive detergents,
cleaning powders/creams or any
sharp objects during cleaning.
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the oven door glass since
they can scratch the surface,
which may result in shattering of
the glass.
Do not use steam cleaners to
clean the appliance as this may
cause an electric shock.

Cleaning the hob

Cleaning the burner
1. Remove the saucepan carriers from
the hob.
2. Remove all removable parts of the
burner and clean only by hand with
sponge, some detergent and hot
water.
3. Clean the non-removable parts of the
burner with a wet cloth.
4. Clean the plug and thermal element (in
models with ignition and thermal
element) with a slightly moist cloth.
Afterwards, dry with a clean cloth.
Make sure that flame holes and plug
are totally dry.
Otherwise, no spark occurs at the end
of ignition.
5. When placing the pan supports, pay
attention to place the pan supports so
that the burners are centered.
23/EN