Table of Contents
Advertisement
DANGER:
Before starting any work on the electrical
installation, disconnect the product from the
mains supply.
There is the risk of electric shock!
Power cable plug must be within easy reach
after installation (do not route it above the
hob).
Plug the power cable into the socket.
Gas connection
DANGER:
Product can be connected to gas supply
system only by an authorised and qualified
person or technician with licence.
Risk of explosion or toxication due to unpro-
fessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures carried
out by unauthorised or unlicensed persons.
DANGER:
Before starting any work on the gas installa-
tion, disconnect the gas supply.
There is the risk of explosion!
•
Gas adjustment conditions and values are
stated on labels (or ion type label).
The gas type of your product is stated on type
label placed bottom of hob.
Connecting the gas hose For NG
•
Natural gas installation must be prepared
before installing the product.
•
There must be a pipe (Piping advised to be
buyed from a licensed installer), must comply
with local gas standard, at the outlet of the ins-
tallation for the natural gas connection of your
product and the tip of this pipe must be closed
with a blind plug. Service Representative will
remove the blind plug during connection and
connect your product by means of a straight
connection device (coupling).
•
Make sure that the natural gas valve is readily
accessible.
•
If you need to use your product later with a
different type of gas, you must consult the Aut-
horised Service Agent for the related conver-
sion procedure.
14/EN
Connecting the gas hose For LPG
•
Have your product connected in a way that it
will be close to the gas connection and not gas
leakage will exist.
•
Plastic hose to be used must not be longer than
125 cm.
•
Install the clamp to the hose. Soak one end of
the hose (15 mm inner diameter) into boiling
water for one minute to soften it.
•
Than, slip the softened end of the hose comple-
tely onto the sharp hose tip of your product. Fi-
nally, tighten the clamp completely with a
screwdriver.
•
Repeat the same procedure for the other end of
the hose and complete the gas cylinder connec-
tion.
•
Never forget to make the gas leakage control.
DANGER:
Risk of explosion and suffocation!
Do not keep LPG cylinders in home.
•
If you need to use your product later with a
different type of gas, you must consult the Aut-
horised Service Agent for the related conver-
sion procedure.
1
LPG hose tip
2
Plastic hose
Leakage control at the connection point
•
Make sure that all knobs on the product are
turned off. Make sure that the gas supply is
open. Prepare soapy foam and apply it onto the
connection point of the hose for gas leakage
control.
•
Soapy part will froth if there is a gas leakage. In
this case, inspect the gas connection once ag-
ain.
Never use a match or lighter to make the gas
leakage control.
Advertisement
Table of Contents
