Luxman C-10X Owner's Manual page 21

Memory
This unit stores the following items when the operation button
is off or the main power is off:
Item
INPUT
OUTPUT MODE
BI-AMP
BAL PHASE
OFFSET
BAL INVERT
DIMMER
ZOOM
LOUDNESS
LINE-STRAIGHT
EXT PRE
Volume level
Memory reset
All settings can be restored to the factory defaults by the fol-
lowing steps:
(1) Put into the standby state.
(2) Hold down the operation button on the main unit for 5
seconds or more and press the dimmer button on the
accessory remote control once while holding down the
operation button.
This will fully reset the memory.
Factory default
Item
INPUT
OUTPUT MODE
BI-AMP
BAL PHASE
OFFSET
BAL INVERT
DIMMER
ZOOM
LOUDNESS
LINE-STRAIGHT
EXT PRE
Volume level
Default
Selected source
Selected mode
L-Hi: ±6 dB, R-Hi: ±6 dB
INPUT-1, 2, 3: 3±, 2±
OUTPUT: 3±, 2±
BAL LINE-1, 2, 3: 0 to −6 dB
LINE-1, 2, 3: 0 to −6 dB
NORMAL/INVERT
Normal/Dim/Very dim/No light
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Set dB value
Default
LINE-1
UNBALANCE
L-Hi: 0 dB, R-Hi: 0 dB
INPUT-1, 2, 3: 3+, 2−
OUTPUT: 3+, 2−
BAL LINE-1, 2, 3: 0 dB
LINE-1, 2, 3: 0 dB
NORMAL
MAX (Normal)
OFF
OFF
OFF
OFF
Minimum (mute/– – – – display)
CONTROL AMPLIFIER C-10X
Prohibition display and caution
When tried to change the setting and failed, an error display
shown in the table below will be displayed.
Display Caution
UNBALANCE When unbalanced is selected for
MODE!! both the input and output, the bal-
anced phase cannot be inverted.
BI-AMP MODE!! When the bi-amp output is selected,
balanced input is unavailable to
select.
BI-AMP MODE!! When the bi-amp output is selected,
the balanced phase cannot be
inverted.
STRAIGHT ON!! When the line straight button is set
to on, loudness is unavailable to
select.
EXT PRE MODE!! When the external pre button is set
to on, mute is unavailable to select.
EXT PRE MODE!! When the external pre button is set
to on, the output mode cannot be
changed.
IN: BAL.-* When the balanced input is selected,
VOL: -**.* switching to the bi-amp output mode
is unavailable.
(The display does
not change.)
19