Luxman C-10X Owner's Manual page 15

Before Connecting
Before connecting other devices, connect the jack side of the
accessory power cable to the AC inlet of this unit.
When connecting, turn off the power button of this unit and
the power supplies of auxiliary devices to prevent unexpected
accidents that may be caused by noise.
Connecting to the power supply
Insert the accessory power supply cable plug into an AC out-
let on the wall of the listening room.
How to connect the input terminals to
input devices such as a CD player
Connect between the output terminals of an input device
such as a CD player and the input terminals of this unit with
pin-plug cables or balanced cables.
Take extra care not to incorrectly connect between right and
left channels. If the right and left channels are connected
reversely, the localization of sound images will deteriorate,
thus failing in normal stereo playback.
If pin-plug cables are used, inadequate connection of the
grounding of the cables may generate noise including a hum,
resulting in an adverse S/N ratio. Carefully insert the connec-
tion plug correctly.
How to connect the output terminals to
output devices such as a power amplifier
Connect between the input terminals of an output device
such as a power amplifier and the output terminals of this unit
with pin-plug cables or balanced cables.
Take extra care not to incorrectly connect between right and
left channels. If the right and left channels are connected
reversely, the localization of sound images will deteriorate,
thus failing in normal stereo playback.
If pin-plug cables are used, inadequate connection of the
grounding of the cables may generate noise including a hum,
resulting in an adverse S/N ratio. Carefully insert the connec-
tion plug correctly.
CONTROL AMPLIFIER C-10X
How to connect between the trigger input
terminal and other devices
Use a commercially available 3.5 mm monaural mini-plug
cable to connect to a device with a trigger output terminal.
This connection enables this unit to turn to operation/standby
in conjunction with the connected device.
When connection is conducted from a product made by other
than LUXMAN, make sure that the trigger output is 12 V.
The trigger input of this unit should be 12 volts, the power
consumption is 13 mA.
How to connect between the trigger output
terminal and other devices
Use a commercially available 3.5 mm monaural mini-plug
cable to connect to a device with a trigger input terminal.
This connection enables the connected device to turn to
operation/standby in conjunction with this unit.
The maximum 12 V output current that can be supplied from this
unit is 100 mA as a total of 1 and 2. Be aware that a malfunction
may be caused if a load more than the above is applied to this
unit by connecting such a device or causing a short circuit.
When this unit is connected to an input/output device, turn off
the main power button of this unit or turn this unit to standby
to protect the amplifier and speakers from excessive input.
Be sure also to turn off the power of the input/output device
to connect with this unit. After completing the connection,
firstly ensure that the connection is appropriately performed
and then put both this unit and the input/output device into
the operating state.
13