Table of Contents
Advertisement
Bi-amplifier/stereophonic reproduction
How to connect the input terminals to
input devices such as a CD player
When the bi-amp output is selected for the output mode
of this unit, only the unbalanced input terminal is enabled.
Therefore, no sound will be generated if connecting an input
device to the balanced input terminal.
Connect between the unbalanced output terminals of an
input device such as a CD player and the unbalanced input
terminals of this unit with pin-plug cables.
Take extra care not to incorrectly connect between right and
left channels. If the right and left channels are connected
reversely, the localization of sound images will deteriorate,
thus failing in normal stereo playback.
Also, inadequate connection of the grounding of the pin-
plug cables may generate noise including a hum, resulting
in an adverse S/N ratio. Carefully insert the connection plug
correctly.
How to connect the output terminals to
output devices such as a power amplifier
When the bi-amp output is selected for the output mode
of this unit, only the unbalanced output terminal is enabled.
Therefore, no sound will be generated if connecting an output
device to the balanced input terminal.
Connect between the unbalanced input terminals of an output
device such as a power amplifier and the unbalanced output
terminals of this unit with pin-plug cables.
Take extra care not to incorrectly connect between right and
left channels. If the right and left channels are connected
reversely, the localization of sound images will deteriorate,
thus failing in normal stereo playback.
Also, inadequate connection of the grounding of the pin-plug
cables may generate noise including a hum, resulting in an
adverse S/N ratio. Carefully insert the connection plug correctly.
The L-terminal of LINE-1 is for output of the L channel of the
low frequency range and the L-terminal of LINE-2 is for output
of the L channel of the high frequency range. The R-terminal
of LINE-1 is for output of the R channel of the low frequency
range and the R-terminal of LINE-2 is for output of the R
channel of the high frequency range.
Sound volume adjustment of the unbalanced output terminal
of LINE-2, that is for output of the high frequency range, can
be controlled up to ±6 dB in increments of 0.5 dB by the pre-
set operation using the accessory remote control.
CONTROL AMPLIFIER C-10X
How to connect between the trigger input
terminal and other devices
Use a commercially available 3.5 mm monaural mini-plug
cable to connect to a device with a trigger output terminal.
This connection enables this unit to turn to operation/standby
in conjunction with the connected device.
When connection is conducted from a product made by other
than LUXMAN, make sure that the trigger output is 12 V.
The trigger input of this unit should be 12 volts, the power
consumption is 13 mA.
How to connect between the trigger output
terminal and other devices
Use a commercially available 3.5 mm monaural mini-plug
cable to connect to a device with a trigger input terminal.
This connection enables the connected device to turn to
operation/standby in conjunction with this unit.
The maximum 12 V output current that can be supplied from this
unit is 100 mA as a total of 1 and 2. Be aware that a malfunction
may be caused if a load more than the above is applied to this
unit by connecting such a device or causing a short circuit.
When this unit is connected to an input/output device, turn off
the main power button of this unit or turn this unit to standby
to protect the amplifier and speakers from excessive input.
Be sure also to turn off the power of the input/output device
to connect with this unit. After completing the connection,
firstly ensure that the connection is appropriately performed
and then put both this unit and the input/output device into
the operating state.
15
Advertisement
Table of Contents
