Download Print this page
SimpliFire Wescott Mantel Kit Instructions Manual

SimpliFire Wescott Mantel Kit Instructions Manual

Advertisement

Quick Links

For Model(s):
SF-INC36
NOTICE: Before starting, the walls and floor in the area of the installation should be clean, plumb and level. Any
major deviation should be remedied before installing the appliance, marble or mantel.
NOTE: To be installed on finished floors only.
Leave this manual with party responsible for
use and operation.
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
CAUTION
• These instructions apply only to the mantel and facing
material that will surround the firebox.
• See the fireplace manufacturer's installation instructions to
ensure that all clearance and installation requirements are
being met.
WARNING
Risk of Fire
• Improper installation or adjustment can
cause injury or property damage.
assistance or additional information, contact
a qualified installer, service agency or the
electrician.
• Comply with all minimum clearances to
combustibles as specified in the appliance
manual.
Tools and Supplies Needed
Phillips Screwdriver (No. 3 preferred)
Tape Measure, Pencil
Portable Drill
1/16" and 3/32" Drill Bits
T10 Driver/Bit
Hammer
Stud Finder
Nail Set
Wescott Mantel Kit
MK-WS-INC36
- Instructions -
For
SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23
CAUTION
It is recommended that two people assemble this mantel due to
its weight and upright positioning.
PREPARATION
Before beginning installation of this mantel, verify that the walls
and floor in the area of the installation are clean, plumb and
level. Any major deviation should be remedied before installing
the appliance, marble or the mantel /cabinet.
These questions should also be considered and answered
before beginning installation of the mantel.
a. Is base molding already installed?
b. Where are the electrical outlets or firebox switch?
c. Is there enough distance between windows and edge
of cabinet?
d. Is the fireplace centered between walls?
e. Will installation interfere with return air vent locations?
f. Is the fireplace centered between windows?
g. Where are the electrical & cable outlets positioned?
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Wescott Mantel Kit and is the answer not in the manual?

Questions and answers

Summary of Contents for SimpliFire Wescott Mantel Kit

  • Page 1 Phillips Screwdriver (No. 3 preferred) • Tape Measure, Pencil • Portable Drill • 1/16" and 3/32" Drill Bits • T10 Driver/Bit • Hammer • Stud Finder • Nail Set SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 2 Left and Right Trim Board 3" SCREWS Ledger Board FINISHING NAILS Top Scribe Molding WALL BRACKET Left and Right Scribe Molding POWER CORD STRAIN RELIEF (pre-installed) (pre-installed) (pre-installed) T-10 SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 3 Step 4 Starting Position Locked Position Do not turn past 1/2 turn Note: Do not overtighten. Overtightening may result in broken fasteners or damage the finished edge of the mantel. SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 4: Product Dimensions

    Note: Make sure electrical receptacle is located in one of the shaded areas. 27-1/8 33-3/4 (689 mm) (857 mm) 6-1/2 5-1/2 (140 mm) (165 mm) (152 mm) (305 mm) SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 5 Remove baseboard from wall where the appliance and mantel will be installed. • Baseboard must be removed where the mantel will be installed. See dimensions on page 4 for refer- ence. SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 6: Appliance Mounting

    (O) at a height of 33-3/4 in. from the floor to the top of the wall bracket. See Figure 3. (O) x 2 (min.) T-10 33-3/4 in (875 mm) Figure 5 Figure 3 SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...
  • Page 7: Connecting To Power

    (O) through the top edge of the mantel. Fill holes with appropriate fill if desired. See Figure 7. Figure 8 SimpliFire, a brand of Hearth & Home Technologies 7571 215 Street West, Lakeville, MN 55044 www.hearthnhome.com SimpliFire • Wescott Mantel Kit Instruction Manual • 4200-935 • 1/23...

This manual is also suitable for:

Mk-ws-inc36