Cleaning The Hot Water Nozzle; Descaling - DeLonghi Dinamica Plus Instructions For Use Manual

9. Refit the lid to the milk carafe.
Please note:
The machine will give a reminder each week of the need for
thorough cleaning of the milk carafe, indicating the correct
procedure.

12.11 Cleaning the hot water nozzle

Clean the nozzle (A8) every time that milk is prepared, using a
sponge to remove milk residues from the gaskets (fig. 20).

13. DESCALING

Important!
• Before use, read the instructions and the labelling relative to
the descaler product, which are indicated on the pack (includ-
ed with certain models and/or available for purchase from
authorized service centres).
• Use De'Longhi descaler only. Using unsuitable descaler
and/or performing descaling incorrectly may result in
faults not covered by the manufacturer's guarantee.
• Descaler can damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler De'Longhi "EcoDecalk" descaler
Container Recommended capacity: 2.0 litres
Time ~30min
Descale the appliance when "DESCALING NEEDED - PRESS OK
TO START (~30min) appears on the display": To descale the
appliance immediately, press
erations from point 3.
To delay descaling until later, press
(B6) appears on the display as a reminder that the ap-
pliance needs descaling. (The message reappears every time the
machine is turned on).
To access the descaling menu:
1. Press the button (C3) to enter the menu;
2. Press "DESCALE" and follow the instructions on the
display;
3. "REMOVE WATER FILTER" (fig. 33): take out the water tank
4. Empty the water tank. Press
5. "DESCALER (LEVEL A) AND WATER (LEVEL B)". Pour the des-
6. "EMPTY DRIP TRAY" (fig. 21):
7. Remove, empty and replace the drip tray (A15) and
8. "POSITION 2l CONTAINER" "OK TO START":
Place an empty container of at least of 2 litres capacity under the
hot water spout (D6) and coffee spouts (A9) ;
and follow the op-
. The symbol
Important! Danger of scalding
Hot water containing acid flows from the hot water and coffee
spouts. Accordingly, take care to avoid contact with this solution.
9. Press
17
(A17), and remove the water softener filter (D4) (if pres-
ent).
caler into the tank up to level A (corresponding to a 100
ml pack) marked on the inner surface of the tank (fig. 34),
then add water (1 litre) up to level B (fig. 35) and put the
water tank back. Press
grounds container (A11). Press
B
A
A
34
to confirm that the descaling solution
has been added. "DESCALING UNDERWAY" "PLEASE WAIT"
is displayed: the descale programme starts and the descal-
er solution comes out of the hot water spout and the coffee
spout; a succession of rinses is performed automatically at
33
;
;
;
B
A
B
35