DeLonghi Dinamica Plus Instructions For Use Manual page 24

PROBLEM
The coffee is weak or not creamy
enough.
The coffee emerges too slowly or
drop-by-drop.
Coffee does not come out of one or
both spouts.
The coffee delivered is watery.
The appliance will not make coffee
The infuser cannot be removed
With the descaling procedure com-
pleted, the appliance prompts for a
third rinse
Milk does not flow from the milk
spout (E5)
POSSIBLE CAUSE
Coffee ground too coarsely.
Coffee not suitable.
Coffee not fresh.
Coffee ground too finely.
The coffee spouts (A9) are blocked.
The funnel (A4) is clogged.
The appliance has detected impurities
in its internal circuits. "Cleaning under-
way" is displayed.
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A17) has not been filled to the
MAX level
The lid (E2) of the milk carafe (E3) is
dirty
The lid (E2) is not correctly in place.
24
REMEDY
Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (fig. 12). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see section "7.5 Adjusting the coffee
mill").
Use coffee for espresso machines.
The coffee pack has been opened for too long
and has lost its taste.
Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
mill is in operation (fig. 12). Continue one click
at a time until coffee delivery is satisfactory.
The effect is only visible after delivering 2
coffees (see section "7.5 Adjusting the coffee
mill").
Clean the spouts with a toothpick (fig. 24B).
Clean the funnel with the aid of the brush (D5)
as described in section "12.8 Cleaning the pre-
ground coffee funnel".
Wait until the appliance is ready for use again
and reselect the required drink. Contact an au-
thorized Service Centre if the problem persists.
Turn the appliance off by pressing the
ton (A7) (see section "5. Turning the appliance
off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A15) to avoid
the water overflowing.
Clean the milk carafe lid as described in section
"12.10 Cleaning the milk carafe".
Assemble all the components correctly as indi-
cated in section "9.1 Filling and attaching the
milk carafe".
but-