ENERGY SAVING
Use this function to enable or disable energy saving mode�
When enabled, the function reduces energy consumption in
compliance with European regulations�
Energy saving mode is active when the green ECO light is on
(fig� 7)�
1� With the appliance off and the main switch in the I
position (fig� 3), press the
until the ECO light comes on (fig� 7)�
2� To disable the mode, press the
the dial)� The ECO light flashes�
3� To re-enable the mode, press the ECO button (on the left
of the dial)
again� The ECO light comes on steadily�
4� Press the
button (on the right of the dial) to
confirm the selection� The ECO light goes off�
Please note :
A few seconds may elapse between energy saving mode
and delivery of the first coffee as the appliance must heat up
again�
WATER SOFTENER FIlTER
Certain models are fitted with a water softener filter� If this
is not the case with your model, you are recommended to
purchase one from De'Longhi Customer Services�
Important:
•
Keep in a cool dry place out of direct sunlight.
•
After opening the pac,, use the filter at once.
•
Remove the filte before descaling the machine.
To use the filter correctly, follow the instructions below�
Installing the filter
1� Remove the filter from packaging and rinse the filter with
about half a litre of tap water (fig� 8)�
2� Rotate the calendar disk so that the next two months are
displayed (fig� 9)�
Please note:
The filter lasts about two months if the appliance is used
normally� If the coffee maker is left unused with the filter
installed, it will last a maximum of three weeks�
3� Remove the tank from the appliance and fill with water
(fig� 1A)�
4� Insert the filter in the water tank and immerse it
completely, sloping it to enable the air bubbles to escape
(fig� 10)�
5� Insert the filter in the filter housing and press as far as it
will go (fig� 11)�
button and hold it down
button (on the left of
(SOmE mODElS ONlY)
6� Close the tank with the lid (fig� 12), then replace the tank
in the machine�
7� Place a container (min� capacity: 100 ml) under the
cappuccino maker�
8� Turn the steam dial in position I to deliver hot water�
9� Let the appliance to deliver hot water for a few seconds, til
the delivery flows regulary, then turn the dial in position 0�
Please note:
It may happen that a single hot water is not sufficient to install
the filter: the lghts
In this case, repeat the installing operation from step 8�
The new filter is active and you can now use the coffee maker�
Removing and replacing the filter
After rwo months (see date indicator) or when the appliance
has not been used for 3 weeks, you should remove the filter
and replace with a new one, proceeding as described at the
previous paragraph�
mAkING COFFEE
Selecting the coffee taste
Turn the coffee taste selection dial (B6) to set the required
taste� Turning it clockwise increases the quantity of coffee
beans the appliance will grind and therefore the strength of
the coffee obtained�
Turn the dial to MIN for an extra mild coffee and to MAX for an
extra strong coffee�
Please note :
•
The first time you use the appliance, you will need to make
a number of coffees to identify the correct dial position
through trial and error�
•
Do not turn the dial too far towards MAX, otherwise the
coffee may be delivered too slowly (a drop at a time),
particularly when making two cups of coffee at the same
time�
11
come on�