DeLonghi Dinamica Plus Instructions For Use Manual page 22

Bean to cup espresso and cappuccino machine
Hide thumbs Also See for Dinamica Plus:
Table of Contents

Advertisement

DISPLAYED MESSAGE
WATER CIRCUIT EMPTY
PRESS OK TO START
PRESS OK TO CLEAN OR TURN
DIAL
DESCALING INTERRUPTED
PRESS NEXT TO CONTINUE
TURN MILK FROTH
ADJUSTMENT DIAL TO CLEAN
POSITION
TURN FROTH ADJUSTMENT
DIAL
SELECT A MILDER TASTE
OR REDUCE COFFEE
QUANTITY
DESCALING NEEDED
PRESS OK TO START
(~30MIN)
REPLACE WATER FILTER
PRESS OK TO START
POSSIBLE CAUSE
The water circuit is empty
A new water softener filter has been inserted
(D4)
The milk carafe has been inserted with the froth
adjustment dial (E1) in the CLEAN position.
Descaling has been interrupted or has not been
completed correctly.
Milk has been delivered recently and the tubes
inside the milk carafe (E) must be cleaned.
A recipe with milk was requested
Too much coffee has been used.
Indicates that the machine needs descaling.
The water softener filter (D4) is exhausted.
REMEDY
Press the selector corresponding to "OK" to
deliver water from the spout (D6) until it flows
out normally.
If the problem persists, make sure the water
tank (A17) is fully inserted.
Make sure the instructions for inserting the
new filter have been followed correctly (sec-
tion "15. Water softener filter"). If the problem
persists, remove the filter (see section 15.3
Removing the filter).
To proceed with the CLEAN function, press
the selector corresponding to "OK", or turn
the froth adjustment dial to one of the milk
positions.
Press NEXT to resume the descaling proce-
dure. For more information, see section "13.
Descaling".
Turn the froth adjustment dial (E1) to CLEAN
(fig. 18).
Turn the dial to the required froth position.
Select a milder taste by pressing the "INTEN-
SITY" button (C5) or reduce the quantity of
ground coffee (maximum 1 measure).
Press the selector corresponding to "OK" to
start descaling or "ESC" to descale later. The
descaling procedure described in section "13.
Descaling" needs to be performed.
Press the selector corresponding to "OK" to re-
place or remove the filter, or "ESC" to carry out
the procedure later. Follow the instructions in
section "15. Water softener filter".
22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ecam380.85.sbEcam382.70.bEcam380.95.tb

Table of Contents