Set Up For Flux-Cored Wire (Fcaw) Welding - Yeswelder YWM-200 Operator's Manual

Cut a slightly longer tube based on the
Ÿ
metal guide tube.

Set up for Flux-Cored Wire (FCAW) Welding

Connect the MIG gun into the EURO CONNECT SOCKET.
Ÿ
Connect the Wire Drive Polarity Lead (9) to the NEGATIVE (-) SOCKET.
Ÿ
Connect the work clamp to the POSITIVE (+) SOCKET. Ensure the work clamp has a good connection to the workpiece and is
Ÿ
connected on clean, bare metal (not rusty or painted).
Load the spool of flux-cored wire inside the cabinet and feed it through the WIRE FEEDER into the gun (see "Installing the
Ÿ
Welding Wire", page 10).
Press the gun trigger or inching button (5) to load the wire through the gun.
Ÿ
Turn the power source on and select the MIG function with the Manual MIG/Synergic MIG/Lift TIG/Stick selector switch.
Ÿ
Set the welding parameters:
Ÿ
Bring the gun close to the workpiece and press the trigger to start welding.
Ÿ
a.Choosing Synergic MIG Setting
1. Choose the material Flux, default wire diameter .035", not able to change the wire diameter size.
2. Adjust the output current with adjustment knob (1), wire feed speed & arc voltage will match automatically.
3. Press selector button(6) to fine tune the auto-adjusted voltage(-5~+5V) to personalize your setting for optimal results. (each 1
value=0.3V, reduce 1.5V~add 1.5V).
4. Press adjustment knob (1) to select welding parameters.
5. Bring the gun close to the workpiece and press the trigger to start welding.
1). STP: Set torch operation 2T/4T.
When 2T operation is selected, press trigger Arc starts, release trigger, Arc stops.
When 4T operation is selected, press and release trigger Arc starts, press and release trigger Arc stops.
2). IND: inductance, adjust the inductance from -10~+10 %with adjustment knob (1), The effects of the inductance can help
reduce spatter, produce a "softer" arc and help wetting out. There is a wetting-out/softness trade off against
penetration/stiff/arc-force/dig qualities.
3). bbt: burn back time, range from 0~10, This setting is used to adjust how long a wire is electrically energized after the wire
has stopped being fed.
4). rin: feeder speed, range from 0~10%.
5). hs: hot start, arc start current, range from 0~10%.
Voltage
110V
220V
b.Choosing Manual MIG Setting
1. Choose the material Flux, and wire diameter .023"~.035". .023" wire not recommend.
2. Adjust wire feeding speed with adjustment knob (1), range from 2~15m/min.
3. Press Voltage/Amperage selector button (6) to adjust the voltage to personalize your setting for optimal results, range from
12.5~30V.
4. Press adjustment knob (1) to select welding parameters.
5. Bring the gun close to the workpiece and press the trigger to start welding.
Replace the inlet guide tube with the
Ÿ
graphene liner and re-install the inlet
guide to the wire feeding mechanism.
Material & Shield Gas
Fe-None Gas
Fe-None Gas
Ÿ
Wire Dia
0.9mm .035"
0.9mm .035"
- 20 -
Install the aluminum spool and feed the
wire through.
Amperage Range
80~160A
80~200A