Controls And Settings - Yeswelder YWM-200 Operator's Manual

Controls And Settings

1. Value Adjustment Knob-Permits selecting different value for output Current, output Voltage, wire feeding speed.
2. Material Selector: 100% CO
3. Process Selection Button: Allows the user to toggle between processes Synergic MIG/Manual MIG/Lift TIG/Stick.
4. Color LED Screen: Permits visualization of welding process and parameters such as welding material, wire diameter, output volt-
age and output current or wire feeding speed current.
5. Wire Feed Button-Press the Wire Feed button to feed the wire through the gun assembly.
6. Voltage/Amperage or Wire feeding speed Selector Button: Permits selecting output.
7. Wire Diameter Selector Button: .023"/.030"/.035"/.045".
MODE
8. Gun Connection (Euro Connect)-Permits attachment of a MIG welding gun. Ensure the gun is fully seated into the brass recepta-
cle.
9. Wire Drive Polarity Lead-Permits configuring the wire drive to positive or negative polarity by inserting into the positive or negative
receptacle. Ensure connector is tightly locked into place by rotating clockwise.
10. Spool Gun Trigger Connector Receptacle-Plug the 2 pin gun trigger connector into this receptacle.
11. Positive Output Receptacle Permits attaching a work lead, electrode stinger or the center wire drive polarity lead to DC positive
polarity. Rotate clockwise to lock into place.
12. Negative Output Receptacle Permits attaching a work lead, electrode stinger, or the center wire drive polarity lead to DC nega-
tive polarity. Rotate connector clockwise to lock into place.
13. Power Switch-Turns power on and off to the machine.
14. Gas Inlet-Shielding gas connects to this inlet, gas fitting: 5/8"~18 RH.
15. Input Power Cable.
16. Fan.
Fe/98% Argon 2% CO Stainless Steel/Flux/100% Argon Aluminum.
2 2
Fe
CO 100%
2
MANUAL
MIG
Fe Ss
Ar 75% Ar 98%
CO 2 25% CO 2 2%
FLUX
STICK
Al
Ar 100%
MATERIAL
.045"
SYNERGIC
MIG
.035"
.030"
LIFT TIG
.023"
- 8 -
INCHING
V/A/