Electrical Grounding Instructions - Hatco AMERICAN RANGE MSD-1 Owner's Manual

Table of Contents

INSTALLATION – ELECTRIC UTILITY CONNECTIONS – STANDARDS AND CODES

WARNING

Qualified installation personnel, licensed and bonded, must be experienced in such work, familiar with all precautions required and

have complied with all requirements of state or local authorities having jurisdiction.

U.S. AND CANADIAN INSTALLATIONS – All ovens, when installed, must be electrically grounded in accordance

with local codes, or in the absence of codes, with the National Electrical Code ANSI/NFPA 70 – Latest Edition

and/or Canadian National Electrical Code C22.2 as applicable.

The ventilation of these ovens should be in accordance with local codes. In absence of local codes, refer to the national ventilation

code titled, Standard for the Installation of Equipment for the Removal of Smoke and Grease Laden Vapors from Commercial

Cooking Equipment, NFPA-96 – Latest Edition.

GENERAL EXPORT INSTALLATIONS – Installation must conform to Local and National Standards. Local installation codes

and/or requirements may vary. If you have any questions regarding the proper installation or operation of your American Range

Convection Oven, please contact your local distributor. If you do not have a local distributor, contact American Range

Corporation at 1.888.753.9898 or visit us at www.americanrange.com

ELECTRICAL CONNECTION – The standard gas operated convection ovens require a 120 VAC, 60 Hz, 20 AMP electrical service

for operation. The supply cord provided on the appliance is equipped with a three-prong (grounding) plug for protection against

electrical shock hazard. The electrical service in the building must be equipped with a properly grounded three-prong receptacle, in

accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or in

Canada – to Canadian electrical codes, CSA C22.2. Do not cut or remove the grounding prong from this plug.

WARNING

For gas fired 120 VAC units and any NEC compliant receptacle, proper ground and correct

polarity is required.

Electric convection ovens are configured at the factory for operation from 208 VAC, single

phase, or 208 VAC, three-phase electrical service is also an available configuration.

WARNING

A70701 RevE 01082024

INSTALLATION

The installation instructions contained here are for the use of qualified installation and

service personnel only. Installation or service by other than qualified personnel will void the

warranty and may result in damage to the oven and/or injury to the operator.