Table of Contents
Advertisement
Removing the Rolled Piece Part
CAUTION:
machine while the roll is pivoted out.
1. Press down on the safety stop bar to de-energize the motor.
2. Turn the two bolts (D) counterclockwise (ccw) which will lower the bottom front roll.
3. Grasp the clamp handle head as shown, and pull out. The top front roll can now be pivoted
out.
4. Remove the piece part from the roll and return the roll to the rest position.
5. Slide the clamp handle head back in to lock the top roll.
6. Press the RESET button on the electrical box to re-energize the motor.
Foot Switch Operation
1. When the Left (L) pedal is pressed down
the material will be drawn into the rolls.
Make sure the front bottom roll is set
properly for the gauge material being run.
2. When the Right (R) pedal is pressed down
the material will back out from the rolls.
To avoid Operator Injury or Machine Damage NEVER run the
19
19
L
R
Advertisement
Table of Contents
