3� 5� 3� Pre-Selecting The Rcf-Value; 3� 5� 4� Pre-Selecting Run Time - VWR avantor Micro Star 21 Instruction Manual

3. 5. 3. Pre-selecting the RCF-Value
1. Enter the desired value by pressing the up or down MINUS / PLUS buttons
repeatedly, until the desired value shows. You can adjust the RCF pre-selected value
in steps of 100 x g.
2. Press START to confirm the pre-selected value.
If you do not press any button, the display flashes for a few seconds. The new
preselected value is now stored and the display shows the actual value.
NOTICE The RCF value can be set to a minimum of 100 x g. The displayed RCF value is always
corresponding to the maximum of centrifuge radius of the 24 x 1.5 / 2.0 mL Rotor. Refer to
Explained" on page 43
NOTICE Avoid if possible speed ranges close to natural resonances of the system. Runs at
resonance speeds may cause vibration and have an adverse effect on the quality of separation.
3. 5. 4. Pre-selecting Run Time
NOTICE You can select a run time between 1 and 99 min or continuous operation.
1. Enter the desired value by pressing the up or down MINUS / PLUS buttons
the display in the middle repeatedly, until the desired value shows. You can adjust the
run time in steps of 1 min.
2. Press START to confirm the pre-selected value.
If you do not press any key, the display flashes for a few seconds. The new preselected
value is now stored and the display shows the actual value.
Operation
for further information.
vwr.com I Instruction manual VWR Micro Star 21
45 / 87
"RCF Value
below