Transmitter Programming - CrimeStopper EZ-777 Operating Instructions Manual

Note: All transmitter codes must be learned at time of programming!! The EZ-777 learns up to 4 different
transmitter codes.
1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire).
2. Turn key to the ON position.
3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
4. Press button #1 & #2 together of the transmitter to be coded. You should get 2 light flashes indicating the unit
nd
is waiting for a 2 code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its
rd
waiting for the 3 code and so on. If all 4 codes are learned, the unit will automatically exit code learning mode,
otherwise turn key off and close hood. See diagram below.
(GRAY WIRE GROUNDED)
1-WAY
COOLSTART
PRESS TOGETHER

TRANSMITTER PROGRAMMING

OFF
START
FLASH 2, 3, or 4 X's
IGN
PRESS 4X's
OFF
12
WAIT FOR
4 FLASHES
IGN